ToneBurst
If you are using a legacy type switch to switch between 2 satellites, setup your port to the
satellite you selected above.
DiSEqC 1.0
If you are using a DiSEqC 1.0 switch to switch between 2, 3 or 4 satellites, setup your port
to the satellite you have selected above.
DiSEqC 1.1
If you are using a DiSEqC 1.1 to switch between 5 to 16 satellites, setup your port to the
satellite you’ve selected above.
Motor
If you are using a motor drive to move between satellites, setup the motor drive by using
DiSEqC 1.2
or
Goto X
protocols.
note
:We strongly advise to ask your local installer to help install motor and settings.
There is also the possibility to change (add, edit or delete) a satellite or transponder by pressing
InFO
and search for channels:
Auto search, Manual search, Blind scan
and
Network search
. Press the
BLUE
button to display the
Scan
menu and press
OK
to confirm.
7.5.2 DvB-t / t2 Installation
In this menu you can select
Country, Antenna power, LCN modes
and search for channels.
Below in the screen you will find level and quality bars for optimizing the best signals of your
terrestrial antenna.
Country Settings
: Select your region.
Antenna Power
: Set to
On
if you use an active antenna. When set to
On
, 5 V will be present at the ANT
IN connector of the receiver. Select
Off
for passive antennas.
LCN
: Set
LCN
(Logical Channel Numbering) to
On
to activate operator defined channel numbering or
Off
to store channels in found order. Sorting of channels in the channel list with LCN is not possible.
Auto Scan
: Select to start searching all frequencies for available channels. All stored channel from
before will be deleted.
Manual Scan
: Select to start searching on one frequency for available channels. All stored channel
from before will be kept in the channel list. When all settings have been made, press
OK
to start
scanning.
Scan Type
: Select
FTA
to search and store channels which can be watched freely. Select
All
to include
encrypted channels in the channel list. However this device does not decode any channels.
7.5.3 DvB-C Installation
For cable installation select
DVB-C
in the
DTV
tuner section. If you don’t make that selection the DVB-T
menu options will be displayed. The process of auto search and manual search works in the same
way as described in the
DvB-t
chapter above.
7.6 Electronic Programme Guide (EPG)
The Electronic Programme Guide (EPG) shows programme schedules and information for current
programmes and coming programmes up to the 7 next days. Press
EPG
button on remote to open
the EPG in viewing mode. To change to other channel, press the
rED
and
GrEEn
buttons. Press
t
upq
to navigate in the EPG menu. Press
OK
to get detailed information about the programme.
Press the
BLUE
Timer
button to set a reminder for a programme or to programme a recording.
21
