Strong 47070-02, Instruction Manual

Page: 8 / 44

10. Dispose of expired bulbs that are beyond warranty in the following manner: Wrap the bulb tightly
in several layers of canvas or heavy cloth. Place it on a hard surface and shatter the envelope with a
sharp hammer blow. DO NOT place an unshattered bulb in an ordinary refuse container.
11. DO NOT PERMIT UNAUTHORIZED PERSONNEL TO PERFORM OR ATTEMPT ANY PHASE
OF XENON BULB HANDLING OR SERVICE.
Cathode Pin
Cathode
Anode
Anode Pin
Cathode End Cap
Seal
Seal
Envelope
Anode End Cap
XG4/006
For use in a Gladiator IV lamphouse, it is necessary to remove the
anode lead (if attached) from the anode end cap of the xenon bulb.
Observe all bulb safety procedures and leave the bulb in its protective
cover. Grasp the bulb by the anode (+) end cap. Use small channel
locks or slip-joint pliers and grip the bulb lead fitting at the crimp joint
nearest the end cap, and unscrew the lead. If the bulb manufacturer
uses a brazed rather than threaded connection, cut the lead from the
end cap, cutting as close as possible to the end cap.
The standard bulb support collet (7200285) measures 4-11/16 inches
(120mm) overall and is designed for a 4000 watt “HS” xenon theater
bulb. When using a smaller, lower wattage bulb, a longer support col-
let (7200638) measuring 6-7/16 inches (164mm) must be installed in
place of the standard collet, and a chromed cathode adapter (7201174)
must be mounted to the bulb’s cathode pin. These components are
included in the optional Bulb Kit 7201175, and both the collet and the
bulb adapter should be mounted prior to installing the bulb.
PRIOR TO INSTALLING BULB, PLEASE NOTE: