18
www.strongpoolsandspas.com
Operate Your Spa
Mode
Standard Mode
is programmed to maintain the
desired temperature. Note that the last measured
spa temperature displayed is current only when the
pump has been running for at least 2 minutes. “ST”
will be displayed momentarily when you switch into
Standard Mode. This is the best mode to use during
COLD weather.
Economy Mode
heats the spa to the set temper-
ature only during filter cycles or if the temperature
falls to 20 degrees below set temperature. “EC” will
display solid when temperature is not current, and
will alternate with temperature when temperature
is current. This is the best mode to use during
WARM weather.
Sleep Mode
also heats the spa to the set temper-
ature only during filtration cycles. “SL” will display
solid when temperature is not current, and will al-
ternate with temperature when temperature is cur-
rent, but only within 20 degrees of your set
temperature.
Note: in all modes, the spa will turn on 1 minute each
hour for a temperature reading.
flashing “END TIME” icon. Adjust the time as done
above.
Press “Mode/Prog” to see the “SET FILTER 2” (PM
cycle) and a flashing “START TIME” icon. Proceed as
above.
Press “Mode/Prog” to see “SET FILTER 2”
and a flashing “END TIME” icon. Adjust the time as
done above.
Pressing “Mode/Prog” will enter the new filter cycle
times into the system and display the current water
temperature.
Pressing “Time” at any time during this program-
ming sequence will save the values entered up to
that point and exit programming.
If you would like to select continuous filtration, set
the filter 1 start and end times to be the exact same
time. In this case, the filter 2 start time only controls
when the second purge happens. Filter 2 end time
will be unavailable.
Light
Press the “Light” button to turn the light on and off.
If left on, the light automatically turns off after 4
hours unless manually turned off prior to 4 hours.
See page 25 for lighting specifics.
Control Pack Codes
See pages 19-23.
__________________________________________
Spas with Touchscreen Panel
See auxiliary manual:
LM8 - Low Maintenance System Installation
and Operation Manual
Summary of Contents for WK01S
