INS-BCAM
01.2
9
.19
Page 2 of 2
phone: 231.947.8600
www.strombergcarlson.com
Step 4:
Connect
c
amera
h
arness to supplied
c
hassis
h
arness.
Make sure to line up the connector arrows.
Use t
ape
or heat shrink after to seal connection.
NOTE:
This camera has grid lines or non-grid lines and
mirror image or non-mirror image options.
Grid line options:
Default setting is to display grid lines. To remove the
grid line display, connect the two green wires near the
end of the camera harness.
Display options:
Default setting is mirror image display for rearward
facing camera (rear view) installation. To change to
a
non-mirror image for forward facing camera (front
view) connect the two white wires near the end of the
camera harness.
Green and white wires on the camera harness.
Step 5:
Plug the new connector into the factory
connector that the factory camera was just
unplugged from. Be sure that the new connector
“clicks” into place.
Step 6:
Secure
your new c
amera
h
arness to
the
existing
vehicle wiring
with cable
/wire ties
. This will
minimize the chance of binding or otherwise
damaging the harness.
Step 7:
Test the system. Inspect that all connections are
proper and secure. Clear all loose items removed
from the area around the vehicle and turn ignition
key ON to test system.
Step 8:
Adjust
c
amera angle if necessary. Loosen camera
screw to aim the camera. Tighten screw at
desired adjustment.
If you are experiencing technical difficulties:
Be sure to reference your vehicle's service manual for any specific camera interface/programming questions prior
to calling Stromberg Carlson Products, Inc. customer service at 231-947-8600 x108