INS-BCAM
01.28.19
Page 1 of 2
phone: 231.947.8600
www.strombergcarlson.com
Backup Camera Installation Instructions
Model # VCD-0043, VCD-0053, VCF-0040
,
VCF-0052, VCG-0048
This kit contains (1)
license plate
-mount CMOS camera with optional grid lines and (1) factory plug-in
harness. Please read thoroughly before starting installation and check that kit contents are complete.
Items Included in the Kit:
Camera on License Plate Mounting Bracket
Factory Plug
-
in
Chassis
Harness
Product Instructions
Tools & Supplies Needed:
Wrench/Screwdriver to fit existing license plate hardware
Electrical tape or heat shrink tubing
Cable/wire ties
Vehicle
s
ervice
m
anual (
i
f needed)
Safety Precautions:
•
Work in a well-ventilated area
,
clear of obstructions.
•
Secure vehicle with chucks
both
in front of and behind tires.
•
Turn vehicle accessories OFF and ensure ignition key is in OFF position.
•
Wear safety goggles and snug fitting clothing.
•
Use tools only for their intended purpose and which are in good repair.
•
Only perform this task if confidence, skill, and physical ability permit.
Step 1:
Place camera in desired position to confirm fitment
(Note: Some states prohibit items blocking the license plate;
check local authorities to confirm legal status for your application)
.
To install
,
first
remove
your
license plate. Reattach
your
plate
,
securing
the camera mounting
bracket behind
it
.
Camera on License
Plate Mounting Bracket
Step 2:
Disconnect the harness that leads from the tailgate
under the back of the bed. There is a different
plug and location for each vehicle make.
Step 3:
Run the new camera harness through the opening in
the back of the bed to the underside of the vehicle.