Check that the flash is
6
ready.
7
Check the flash operation.
Press the master unit’s
Test Button and the slave
unit will fire. If not, adjust
the slave unit’s
sensor
toward the master unit
and
perhaps shorten the
distance from the master
unit.
Set the camera in the
8
same way as with
normal flash shooting.
Press < > button for
1
two times so that < >
blinks.
2
Turn the Select Dial to
choose a channel ID and press
the < > button to confirm.
Set a channel ID.
●
5. Setting the Flash Output for Slave Units
In M manual and Multi stroboscopic flash modes, you can set a
different flash output for each slave unit. All settings are done with
the master unit.
Press < > button to
1
have <
M
> or <
Multi
>
displayed.
Press < > button so
2
that < > blinks on the
LCD panel.
- 17 -
- 18 -
Set the other camera
2
flash(es) as the wireless
slave unit(s).
Check the communication
3
channel. If the master unit
and slave unit(s) are set
to a different channel, set
them to the same
channel.
Position the camera and
4
flashes.
Set the master unit’s
5
flash mode to <
ETTL
>.
For shooting, <
ETTL
>
will automatically be set
for the slave unit(s).
2. Fully Automatic Wireless Flash
This uses E-TTL autoflash to control the total flash output and make
all groups of flashes fire at an average of the total flash output.
Attach a camera flash
1
onto the camera and set
it as the master unit.
●
No matter where the slave unit's flash head is
aimed
, be sure
to make its wireless sensor faces the master unit. Also ensure
that the slave unit is placed within the effective transmission
range of the master unit. Do not place any obstacles between
the master unit and the slave unit(s). Obstacles may block the
transmission of wireless signals.
After positioning the slave unit(s), be sure to test the wireless
flash operation before shooting.
●
●
Even if the master unit flash firing is disabled, it still fires a
preflash to transmit wireless signals.
3. Master Unit’s Flash OFF
When the master unit is set to OFF, only the slave units will fire a
flash.
Set it as the master unit.
1
Press < > button for
few times until < >
and < > blink.
Disable the master unit’s
2
flash firing.
Turn the Select Dial until
< > is displayed. Press the
< > button to confirm.
●
4. Setting the Communication Channel
If there are other wireless flash systems nearby, you can change the
channel IDs to prevent signal interference. The channel IDs of the
master unit and the slave unit(s) must be set to the same.
Summary of Contents for Pro-Flash Tli-C
Page 1: ......
