Strobel VEB100-6, Mechanic'S Instructions

Page: 24 / 42

20
MA_VEB100-6_A2_180618_en
3.5
The machine is equipped with a saw-teethed feed dog. Its movement in relation
to the needle plate can be adjusted after releasing screws. Or it can be
replaced by pyramid-teethed feed dog.
Feed dog
3.5.1 Setting the feed dog
A T T E N T I O N !
Switch off machine electrically.
1. Set stitch length to 8 mm.
2. Clamp the feed dog so that it is parallel to the needle plate and that it
shows the teeth depth under the lower needle plate side. It should not
touch the needle plate opening but it should be placed to the needle as
close as possible.
In the moment of needle penetration it should be possible to clamp a 0.2 mm
sheet of paper between feed plates and needle plate.