Strobel KA-ED, Operating And Mechanic'S Instructions

Page: 45 / 78

41
BA_KA-ED_A22_190313_en.doc
Fig. 23
5.8 Setting the clamping device and the cover panel
5.8.1 Setting the clamping device (Fig. 24)
- Switch off main switch S0.
- Set dimension 195 +1 mm between transport reel (1) and block (2) on both
sides.
- Remove both sides of bracket (3) from piston (2).
- Remove both nuts (4).
- Set pistons on threaded (5) bar to 195 +1 mm (turn on thread).
- Refasten nut.
- Reattach bracket.
- Switch on solenoid 1V2 with the manual switch (clamping device closes).
(Fig. 25)
- Screw piston rod of the cylinder (6) into slideway (7) until the distance between
transport reel (1) and the two setting rings (8) is about 2 mm.
-
Tighten hexagonal nut (9) at slideway (7).
-
Set the speed at solenoid 1V2 as follows (Fig. 25):
-
Turn in upper exhaust throttle setting screw of 1V2 until no more metallic
beating sounds can be heard when the clamping device is closed manually
(manual switch of 1V2 see Fig. 25).
-
Turn in lower exhaust throttle setting screw of 1V2 until no more metallic
beating sounds can be heard when the clamping device opens manually (manual
switch of 1V2 see Fig. 25).