Please keep the original packaging in order to protect the equipment against damage in case you ever need to ship or
transport the auger. If the packaging materials are no longer required then they must be disposed of properly in accordance
with applicable local regulations. Cardboard packaging materials are raw materials which can be recycled or reused. At the end
of the equipment’s service life, please make sure that you dispose of it properly, in accordance with the official directives and
regulations that apply in your area.
!
!
1.
DO NOT
use this product for any purpose other than cutting ice fishing holes. Ice augers are precision cutting
tools built for the ice fisherman, and must be properly maintained and handled with caution during both cutting
and transporting. When not in use, always store with blade guard attached.
2.
DO NOT
use attachments other than those available from the manufacturer.
3.
DO NOT
alter this product in any manner; doing so is dangerous and voids all warranties.
4.
DO NOT
allow children or adults weighing under 100 lbs. to operate this equipment.
5.
DO NOT
operate under the influence of drugs or alcohol.
6.
DO NOT
allow your body, loose clothing, drawstrings, scarves, hats or other materials to come in contact with
the Powerhead, Starter Assembly or Auger (Drill) unit at any time.
7.
DO NOT
operate if, upon pulling the starter rope or after drilling holes, the auger (drill) rotates or if the rope
pulls hard. Have the unit checked by a qualified mechanic.
8.
DO NOT
allow the engine to run or operate while moving or transporting to another location.
9.
DO NOT
continue to use this product in the event of mechanical or electrical failure.
10. This product produces considerable cutting force that is felt by the operator. Make sure your feet are firmly
planted and that the handles are held firmly while operating this product.
11. Always check the operation of the throttle system to ensure the carburetor control is completely returning to
the idle position when the throttle lever is released.
12.
Check cutting blades and auger shaft screws before and after each use to make sure they are tight.
13. During operation, the auger unit could possibly stop. Be prepared at all times to release the throttle lever.
14. The cutting blades on the ice auger are razor sharp. Use extreme care when handling.
It is recommended that everyone who uses this product should read this
StrikeMaster Owner’s Manual before operating.
IMPORTANT SAFEGUARDS
3
1. Recoil (Starter) Handle
2. Fuel Cap
3. Fuel Tank
4. Fuel (FULL) Level
5. Decompression Valve
6. Throttle Lever
7. Air Filter Cover
8. Throttle Arm
13. Recoil
14. Muffler/Cylinder Guard
15. Muffler
16. Handle Assembly
9. Choke Lever
10. Transmission
11. Start/Stop Switch
12. Spark Plug Cover
COMPONENT & CONTROL LOCATIONS
10
11
13
15
14
16
12
8
9
4
5
7
1
2
3
6
PACKAGING & DISPOSAL
!
!
