8
9
!
!
ASSEMBLY
1.
DO NOT
use this product for other than its intended purpose.
2.
DO NOT
use attachments other than those available from the manufacturer.
3.
DO NOT
alter this product in any manner; doing so is dangerous and voids all warranties.
4.
DO NOT
allow children or adults weighing under 100 lbs. to operate this equipment.
5.
DO NOT
allow your body, loose clothing, drawstrings, scarves, hats or other materials to come in contact with the Powerhead,
or Auger (Drill) unit at any time.
6.
DO NOT
operate under the influence of drugs or alcohol.
7.
DO NOT
continue to use this product in the event of mechanical or electrical failure.
8. This product produces considerable cutting force that is felt by the operator. Make sure your feet are firmly planted and that
the handles are held firmly while operating this product.
9. During operation, the auger unit could possibly stop. Be prepared at all times to release the switch.
10. Check cutting blades and auger shaft screws before and after each use to make sure they are tight.
!
!
It is recommended that everyone who uses this product should read this
StrikeMaster OWNER’S MANUAL before operating.
Carefully remove blade
guard and make sure
blade bolts are tight.
1. Motor Cover Knobs
2. Motor Cover
3. Handle
4. Starter Button
5. Transmission
6. Wire Harness Connector
7. Power Jumper Cable
8. Wire Harness Connector
9. Battery Clamps
Remove metric allen
wrench taped to the
neck of auger and
unscrew the collar
bolt from auger.
(8mm bolts and 8mm
closed end wrench)
The large and small holes
from each component
must line up before
installing the collar bolt.
Push down and twist
to line up holes.
Insert auger into drive shaft and
install collar bolt.
Collar bolt inserts into the large
hole, passes through the drive
shaft and threads into the small hole
of the metal collar. Make sure bolt is
tight. Some wiggle is normal between
the power head and auger. Check and
tighten often.
After assembly is complete, you
can conveniently store your allen
wrench on the underside of the
throttle pedal.
It is recommended that the
collar bolt be checked and torqued
firmly before and after every use.
2
2a
2a
3a
3a
3
Metal Collar
Allen
Wrench
Collar Bolt
Large
Holes
Plastic
Collar
Drive Shaft
!
1
3
4
5
2
1
IMPORTANT SAFEGUARDS
3
8mm closed
end wrench
2
4
3
6
5
1
COMPONENT & CONTROL LOCATIONS
7
4
Allen Wrench
Storage
