Attaching the top
fineals.
Front and Back Facias
You will have two parts 4H for the
top head and foot boards. Attach
these using confirmat bolts.
Side Facias
You will find two part 4K, again
attach using connector /barrel bolts.
Once in place now go round and
tighten all bolts.
Attach the two side rails
Firstly ensure there is no sawdust or debris in the access holes. Using a bolt push
through to clear. Now insert the dowel rods at all ends, do not push all the way in.
Make sure the WHITE MARKINGS on each headboard are facing inwards. Now
start with the headboard and connect each side rail to each corner post
Place the barrel bolt within the round access hole on the side rail. Now dip bolt B
into the glue and push through to connect to the barrel bolt. This side rail is
designed not too move so the fixing is tight. Then locate the footboard, again ensure
the WHITE MARKINGS are facing inwards and connect. (See page 5, FIG 5 for
fixings
Attach the side rail support legs
The centre leg will hover slightly off the floor, when
the bed is in use it will move down and support the
bed. This is to protect the leg if the bed moves.
It is important this leg is attached as it supports the
side rail. Measure a half way point on the side rail.
Place the support leg under the side rail from the
outside. Using two black screws attach from the
inside of the side rail. Note there is no access hole as
the screws are self threading