Each corner post will have a white chalk marking, lay the post down and have the
markings facing you, at the top. BL goes to the left, BR goes to the right.
Part 13 Blue
(see page 5, FIG 1 or 2 for fixings)
Now We Build the Footboard
Attach the two side rails
Firstly ensure there is no sawdust or debris in the access holes. Using a bolt push through to clear.
Now insert the dowel rods at all ends, do not push all the way in.
Make sure the WHITE MARKINGS on each headboard are facing inwards. Now start with the
headboard and connect each side rail to each corner post
Place the barrel bolt within the round access hole on the side rail. Now dip bolt B into the glue and
push through to connect to the barrel bolt. This side rail is designed not too move so the fixing is
tight. Then locate the footboard, again ensure the WHITE MARKINGS are facing inwards and
connect. (See page 5, FIG 5 for fixings
Attach the side rail support legs
If you have ordered a guest bed simply do not attach the side rail support leg to the front. If
you have ordered drawers still attach as instructed.
The centre leg will hover slightly off the floor, when
the bed is in use it will move down and support the
bed. This is to protect the leg if the bed moves.
It is important this leg is attached as it supports the
side rail. Measure a half way point on the side rail.
Place the support leg under the side rail from the
outside. Using two black screws attach from the
inside of the side rail. Note there is no access hole as
the screws are self threading
BL
BR
