4
R&E Stricker Reha-Entwicklungen GmbH
Additional operating instructions Lipo Smart
Operation
Only charge the battery at temperatures between
0 and 40 °C. A charging process outside the
temperature range is automatically aborted by the
battery. To optimize the service life, charge the
battery at temperatures of 10-30 °C.
Charge the battery in a sufficiently ventilated, dry
and dust-free environment. Ensure sufficient air
circulation during the charging process.
Do not charge the battery near flammable
substances (solids, liquids, gases).
Protect the battery from moisture during the
charging process. Do not charge the battery in
rooms where water could condense on the battery
or the charger. Only use the charger when it is
completely dry. If condensation has formed, allow
the charger to dry completely before charging.
Only use the charger supplied to charge the
battery. Using any other charger may cause
malfunction, damage, defect, ignition or explosion.
Do not charge the battery with a defective charger.
Replace a defective charger immediately.
Do not use a charger that has been knocked
or dropped. Do not open or repair the charger
yourself.
Do not charge damaged batteries.
Avoid unnecessary charging and do not charge the
battery for a long time when not in use.
The battery charging process is automatically
terminated as soon as the battery is fully charged.
When charging is complete, first disconnect the
charger from the mains socket and then from the
battery.
Do not carry the charger by the mains cable or the
charging cable. Do not pull on the mains cable to
disconnect the charger from the mains socket. Do
not subject the cables and plugs to pressure or
pinch the parts. There is a risk of electric shock or
ignition.
Position the charger so that no one can step on
or trip over the cable or charger. Also protect the
charger and all related components from other
harmful influences or stresses.
5.1.3 Storage
Do not store the batteries in places that are
exposed to heat for long periods of time (sunlit
car boot, garden shed, etc.). The service life of
the battery depends, among other things, on the
storage conditions.
Only use your car for transport, not for storing or
keeping the battery.
For optimum service life, store the battery at
18-23 °C and a maximum humidity of 80 %. Do not
expose the battery to moisture (rain, snow, etc.)
during storage.
Charge the battery before storage according to
the specifications of the respective battery. Check
the charge level at least every three months and
recharge the battery if necessary. („
Ensure that the battery is stored away from
damage and unauthorised access.
Store the battery out of the reach of children.
6 Operation
WARNING
Switch off the battery when coupling or
uncoupling from the wheelchair and maneuvering
or, alternatively, turn the speed controller on the
handlebar to 0 to prevent unintentional driving off
when moving the cranks.
6.1 Lipo Smart model series
6.1.1 Start driving
NOTE
Unpacking and installation video can be found on
www.stricker-handbikes.de/installationsuppo
rt
WARNING
When parking the traction unit, always remove the
key for the key switch to prevent unauthorised use
of the unit.
Switch on the battery using the main switch on the
battery. You will know that the battery is on when
the light on the battery is on (
Turn the key switch with the key to the „
ON
“
position . Remove the key and stow it securely so
as not to lose it while driving (
).
