30
STEP 4: Adjusting the Sensitivity
STEP 5: Putting the Collar on Your Dog
There are two BUTTONS “+” and “-“used to adjust the sensitivity level. As a default, the sensitivity
level will be on the 4th level every time you install the battery.
By adjusting the buttons, the sensitivity will gradually be enhanced or weakened. The higher the
sensitivity level is, the easier it is to trigger the collar.
Put the collar around your dog’s neck and adjust the length of the collar using the slide buckle
arrangement. The collar should fit snugly underneath your dog’s neck. Make sure the probes are
one finger width apart from the dog’s neck (stick your finger between the dog’s neck and the probes
to check).
⇨
CORRECT FIT:
the collar is not moving and you can slide JUST ONE finger under the collar or
strap.
⇨
INCORRECT FIT:
The collar is moving and you can slide TWO fingers under the collar or strap. In
this situation, the collar will go off randomly and is not working correctly when your dog is barking.
Make sure the vibration probes are in direct contact with your dog’s skin. Hair between the probes
and skin will diminish the effect of the vibration. We advise clipping or shaving the dog’s fur under
the neck to ensure direct contact.
Ensure that no more than one
finger can pass through.
WARNING:
