EN
- Be aware that the heater may become hot during operation, so place it on a
stable, horizontal, heat resistant surface (e.g., stone, marble, tile) out of reach
of children and away from flammable materials (such as curtains) to allow easy
access and removal of the power plug! Never locate the appliance directly in
corners and observe the minimum mounting distances.
WARNING:
Do not
cover! Covering the appliance can cause overheating, fire or electric shock!
- Set the heater to mode
.
- Connect the fan heater to the mains.
- Set the thermostat knob to position MAX.
- The heater will be switched on by setting to one of the four operating modes (
,
,
,
).
The thermostat can be used to set the ambient temperature of the room. In modes
,
or
the
appliance will switch on when the ambient air temperature falls below the value set. As the set temperature is
reached, the heating elements turn off while the fan continues to operate.
- If you would like to set a higher temperature, turn the thermostat knob clockwise, if you want to set it lower,
then turn it counterclockwise.
- Before switching off set the switch knob to mode
so that only the fan operates. Cool the appliance this
way for 2 minutes then switch it off.
- In the event of overheating, the self-resetting cut-out will switch off the unit, for example when the air inlets
and outlets are covered. Power off the unit by unplugging it from the electric outlet. Allow the appliance to cool
(for at least 30 minutes). Check whether the air inlets and outlets are obstructed or not, and clean them if
necessary. Switch on the unit again. If the self-resetting cut-out activates again, power off the unit by unplugging
it from the electric outlet and contact an authorized service center.
- When using the heater for the first time, you may notice a slight emission of smoke. This is quite normal and it
stops after a short time. The heating element is made of steel and was coated with a layer of protection oil by
production. The smoke is caused by the left oil when heated.
CLEANING AND MAINTENANCE
- Before cleaning the appliance, disconnect it from the socket and let it cool down.
- The enclosure is easily to get dirty, wipe it often with soft sponge. For very dirty parts, wipe with a sponge
dipped in < 50
℃
water and mild detergent, then dry the heater enclosure with clean cloth.
- Be careful not to let the water enter the appliance inner. Don’t splash water onto the heater, never use solvent
like gasoline, isoamyl acetate, toluene etc. to clean the heater, in order to protect the enclosure.
- Clean the coupler, dry and pack it in a plastic bag.
- When you store the heater, let it cool down first, keep it dry. Then cover it with a plastic bag, put in the packing
box and store it in a dry, ventilated place.
TROUBLE SHOOTING
- You can solve many common problems easily, saving you the cost of a possible service call. Try the suggestions
below to see if you can solve the problem before calling the authorized service center.
