Street Guardian SG9663DR, User Manual

Page: 19 / 29

bracket too soon after installation the adhesive may not bond
correctly to the glass.
[Note] When determining the mounting locations be sure to leave
adequate room to be able to detach the cameras.
It is always advisable where possible to route any cables across the
passenger side of the vehicle to avoid any chance of cables interfering
with control of the vehicle or causing a distraction to the driver
should a cable become loose. Any cables that are routed through the
A pillar or roof area where there are SRS airbag systems must be
routed so that the cables are fixed behind the airbags so as not to
interfere with the operation of the vehicle safety systems.
4. Before mounting the DVR main unit ensure that there is enough
room to access and remove the memory card, there is sufficient
room for the cables, and adequate clearance for access, if
mounted to a vertical surface the adhesive dual lock tape is a
better choice than the adhesive magnet mounts, choose the
mounts that best suit your application
[Note] If the main unit is not mounted securely it will affect the
performance of the built in G-Sensor.
5. Choose a suitable location for the GPS, it must be mounted with
the GPS logo facing up with adequate access to signal, mounted
to the top of the dash or similar, it can be mounted under the
dash if the dashboard is plastic and does not have any steel panel
or vehicle electronics in the chosen location that could inhibit the
signal, the GPS cable can be extended using a typical 75ohm
3.5mm male to 3.5mm female extension lead if required.