Stratus V 6624, Hardware Installation Manual

Page: 49 / 78

Powering On the System
Connecting and Powering On the System 2-17
Logically install each tape drive in the enclosure (one or two drives) by adding the
drive(s) to OpenVOS with the OpenVOS
setup_tape
command. For information on
the
setup_tape
command, refer to the OpenVOS System Administration: Disk and
Tape Administration (R284) manual.
Powering On the System
This section discusses the following topics:

“Powering On the Components” on page 2-17
This section discusses powering on the PDUs, UPS units (if included),
ftScalable Storage G3 enclosures, tape-drive enclosures (if included), RSN
modem (if included), and PC console.

“Powering On the ftServer System” on page 2-21
Powering On the Components
Perform the following steps to power on the system’s components.
1. To power on the PDUs, perform steps a through c for each PDU in the system.
N O T E S
1. The system has a minimum of two PDUs and a
maximum of four PDUs, based on the configuration
and options.
2. System components have dual power cords and are
connected to separate PDUs for redundancy. Follow
factory cabling if you are replacing components or
installing optional components.
3. The PDUs are mounted vertically along the left and
right vertical rails at the rear of the cabinet.
a. At the rear of the cabinet, connect the power-jumper cords (number 3 in
Figure 2-12 ) from the system components to the PDU.
b. Connect the PDU power-input cord (number 2 in Figure 2-12 ) to the PDU and
to a separate AC power source.
c. Turn on the breaker switch (number 1 in Figure 2-12 ).