Stratus V 6624, Hardware Installation Manual

Page: 46 / 78

Connecting External Components to the System
2-14 Stratus ftServer V 6624 Hardware Installation Guide (R005S)
Installing the Optional Tape-Drive Enclosure
You will need two side rails, eight side-rail screws, and two cabinet screws (front) with
washers and spacers to perform the installation.
N O T E
Removing the 1U bezels above and below the tape-drive
enclosure will allow you better access during this
procedure.
1. Attach the two side rails to the tape-drive enclosure by aligning the screw holes in
the side rails (see Figure 2-9 ) with the holes in the side of the drive. Place the rails
as shown in the figure. Attach four screws to each rail.
Figure 2-9. Attaching the Rails to the Tape-Drive Enclosure
v os243