Stratus V 6624, Hardware Installation Manual

Page: 26 / 78

Setting Up the Pallet Ramp
1-14 Stratus ftServer V 6624 Hardware Installation Guide (R005S)
13. Lower the cabinet back to a standing position.
14. Move the lever bar to the opposite side of the system and repeat steps
11 through 13 .
Setting Up the Pallet Ramp
The pallet ramp comes in two pieces that are bolted together. The ramp is secured to
the front of the cabinet on the pallet. To assemble the pallet ramp and secure it to the
pallet, perform the following procedure:
1. With the pallet ramp separated from the pallet (performed in step 3 in the previous
procedure), remove the bolt (see Figure 1-11 ) at the upper edge of the ramp and
separate the lower end of the pallet ramp.
Figure 1-11. Removing Bolt
2. Fit the beveled edge of the lower end of the pallet ramp into the lower edge of the
upper end of the ramp as shown in Figure 1-12 .
upk009a
Bolt