Cut side frame at the
top of slot to leave
8mm space at the top
and bottom of frame
TIP: Remove gate
top caps before
cutting down
Using an aluminium saw, cut the
gate side frames
and
outer infills
to the required height. Gates
are pre-made at 5’ 11” (1797mm) high but can be
height adjusted as required.
NOTE: Side frame heights are governed by the
slotted spacer
Gates are pre-made at 3’ 3 1/2” (1000mm) wide
“Overall gate width” (outer edge of gate frame to
outer edge of gate frame). If a narrower width is
required, refer to below:
Using an aluminium saw, cut all
slats
and
gate
slats
to suit the required overall gate width. If
height of gate is reduced, count how many slat
spaces are required to suit that height.
Note: You must always use 4x gate slats to
make a gate
You need to allow for hinge and latch
gaps. Check hinge and latch hardware
specifications for gaps required and
take this information into account when
determining OVERALL GATE WIDTH
HEIGHT ADJUSTMENT OF GATE FRAME
WIDTH ADJUSTMENT OF SLATS
ACTUAL SLAT WIDTH
=
OVERALL GATE WIDTH
(i.e. outer edge to outer edge of gate side frame
MINUS
1 7/16” (36MM)
!
1
2
1
2
OFFCUT
(A
fter side frame is cut down)
G
ATE SIDE FRAME
TOP OF GATE
NOTE
NOTE
PEDESTRIAN GATE
ASSEMBLY GUIDE
