Rivet
Ball cap
Post cap
Rivet Position
Fixing detail
Install ball or post cap
Install ball or post cap
Insert post infill
Insert post infill
POST ON A FENCE END
POST ON A STEPPED PANEL
Post infill
Post caps or ball caps are an optional item that can be ordered with a new fence or
added to an existing Stratco fence. Caps must be installed upon completion of the
fence. Place the chosen cap on top of the two joined posts. Push the cap into position.
Drill one hole either side, through both the cap and post, then rivet into position, as
shown in Figure 10.0. Plain post caps can be cut in half when used on an end post.
Post infills are used to tidy up an exposed post end on stepped panels or end panels
where post caps or ball caps are intended to be used. The infill will need to be cut to
the required length before being slid into the exposed post. The post or ball cap can
now be installed. The cap also prevents the infill from being removed.
Figure 10.0
Figure 9.0
MAINTENANCE REQUIREMENTS
POST INFILL
Fencing should not be located within 1000 metres of a marine environment or in
severe industrial or corrosive environments. For more information refer to “Selection,
Use and Maintenance of Stratco Steel Products” Brochure.
POST CAP INSTALLATION
CONTACT
1300 165 165
www.stratco.com.au
All brands
and logos/images accompanied by ® or ™ are
trade marks of Stratco (Australia) Pty Limited.
BROCGNI
©
Copyright April 04
