Site Preparation Guide
Preparing For Installation
Page 12
Unpacking the Printer
The panels of the V650 Flex printer shipping crate are marked “Front”, “Back”, “Left”, “Right”
“Top” and “Bottom”. The marked panels will correspond with the sides of the V650 printer
inside.
Remove Shipping Materials
1. Inspect the Tilt Indicators (2) and ShockWatch indicator affixed to the exterior of the crate.
If possible, take a picture of these indicators to share with your installation representative. If
damage is detected upon installation, this photo will assist your installation representative
in determining the cause of damage (
).
Figure 8: Shipping Crate Damage Indicators
Do not displace any of the shipped loose items or attached hardware packets
included with the printer. Keep all unassembled items with the system.
If damage has been detected, do not continue unpacking until a certified
Stratasys technician has been contacted.
ShockWatch
Indicator
Tilt Indicators