Stratasys uPrint, Service Manual, Page: 61 / 383

4-14
Door Sensor
Required Tools
•
5
⁄
16
” nut driver or standard screwdriver.
Removing the door sensor
1.
Remove the display panel. See Removing the display panel on page 4-9.
2.
Remove the front panel. See Removing the front panel on page 4-11.
3.
Disconnect the DRSW cable. See Figure 4-30.
Figure 4-30: Door sensor cable location
4.
Gently pull the door sensor out of the mounting plate. See Figure 4-31.
Figure 4-31: Removing the Door Sensor
Installing the door sensor
1.
Gently push the door sensor into place on the mounting plate.
2.
Connect the door sensor (DRSW) cable.
3.
Install the front panel. See Installing the front panel on page 4-12.
4.
Install the display panel. See Installing the display panel on page 4-10.
Disconnect the DRSW
cable.