Stratasys uPrint, Service Manual, Page: 345 / 383

7-2
Startup kit tools
The startup kit contains a set of tools used to help you maintain the printer. The following is
a list of the tools contained in the startup kit.
• Needle nose pliers
• T-Handled allen wrench - 1/8 inch
• T-Handled allen wrench - 7/64 inch
• Gloves
(Leather)
• Cutters
• Brush
• Magnifier
Preventive Maintenance
Daily
Empty the purge bucket
Empty the purge bucket after each build has completed.
Inspect the tip wipe assembly
After each build you should inspect the tip wipe assembly to make sure there is no material
build up. If there is material build up, clean the tip wipe assembly. Material build up on the
tip wipe assembly can cause part quality issues. See
Tip wipe assembly on page 7-3.
Inspect the tip shields
After each build you should inspect the tip shields for damage or material build up. If there
is material build up remove it as needed. If the material will not break free or there is
damage to the tip shield, replace the tip shield. See
Tip shield replacement on page 7-5.
Remove debris buildup
Remove all material buildup on the Z platform and around the lead screw. Failure to do so
could cause the base to not be level or the Z platform to jam at its upper limit.
Vacuum build chamber
Vacuum the build chamber to remove all debris and purged material.
Clean door
Do not use ammonia based glass cleaner on the door. It will damage the acrylic window.
Caution: ONLY use acrylic cleaner.