Stratasys uPrint, Service Manual, Page: 235 / 383

5-26
Figure 5-323: Measuring diameter of circle D
20.
Add the lengths derived from steps 17 and 18 (A-D and D-G) and then subtract the width
of circle D derived from step 19 . Record this total as “GLeft”
21.
Measure and record the distance from the outside edge of circle G to the outside edge of
circle H. See Figure 5-324.
Figure 5-324: Measuring distances from outside edges of G and H
22.
Measure and record the distance from the outside edge of circle H to the outside edge of
circle I. See Figure 5-325.
Figure 5-325: Measuring distances from outside edges of H and I
23.
Measure and record the diameter of circle H along the center line between G and I. See
Figure 5-326.
Figure 5-326: Measuring diameter of circle H
24.
Add the lengths derived from steps 21 and 22 (G-H and H-I) and then subtract the width
of circle H derived from step 23 . Record this total as “GRear”