Stratasys uPrint, Service Manual, Page: 225 / 383

5-16
12.
Next measure and record the distance from the outside edges of circle B and C, see
Figure 5-300. Ensure that the caliper is not seated on the small bump of circle C.
Figure 5-300: Measuring distance from outside edges of B and C
13.
Add the lengths derived from steps 11 and 12 (A-B and B-C) and then subtract the width
of circle B. Record this total as “Front”
14.
Measure and record the distance from the outside edges of circles E and F. Ensure the
caliper is not seated on the small bump of circle E. See Figure 5-301.
Figure 5-301: Measuring distances from outside edges of E and F
15.
Measure and record the distance from the outside edges of circles F and G. Ensure the
caliper is not seated on the small bump of circle G. See Figure 5-302.
Figure 5-302: Measuring distances from outside edges of F and G
16.
Measure and record the diameter of circle F along the center line between E and G. See
Figure 5-303.
Figure 5-303: Measuring diameter of circle F
17.
Add the lengths derived from steps 14 and 15 (E-F and F-G) and then subtract the width
of circle F derived from step 16 . Record this total as “Rear”
18.
Measure and record the distance from the outside edges of circles C and G. Ensure the
caliper is not seated on the small bump of circles C or G. Record this total as “Right”, see