Stratasys uPrint, Service Manual, Page: 173 / 383

4-126
9.
Remove the belt fixture and move the belt forward and back several times.
10.
Reattach the belt tension gauge and recheck the tension.
11.
Continue to adjust and check the tension until the tension meets specification.
12.
Push the left side Y guide rod in towards the back of the printer.
13.
Rotate the left side Y guide rod towards the left side of the printer and raise the guide rod
to the top of the frame.
14.
Lower the left side Y guide rod into its mounting location.
15.
Using a
5
⁄
32
” allen wrench, loosely reinstall the left side rear Y guide rod mounting
screw.
16.
Using a
5
⁄
32
” allen wrench, loosely reinstall the left side front Y guide rod mounting
screw.
17.
Reconnect the Y home sensor cable.
18.
Align the right side Y guide rod with the mounting holes.
19.
Using a
5
⁄
32
” allen wrench, loosely reinstall the right side rear Y guide rod mounting
screw.
20.
Using a
5
⁄
32
” allen wrench, loosely reinstall the right side front Y guide rod mounting
screw.
21.
Align the X guide rods with the mounting holes.
22.
Using a
5
⁄
16
” nut driver or standard screwdriver, loosely reinstall the right side X guide
rod mounting screws.
23.
Align the X motor energy chain mounting bracket with the mounting holes.
24.
Using a
5
⁄
16
” nut driver or standard screwdriver, reinstall the 2 X motor energy chain
mounting screws.
25.
Reconnect the X motor cable.
26.
Reinstall a wire tie around the X motor cable connector. See Figure 4-223.
Figure 4-223: X motor wire tie locations
27.
Place the right side Y belt into the retaining clip.
Reinstall wire
tie