Stratasys uPrint, Service Manual, Page: 168 / 383

uPrint/uPrint SE Service Manual 4-121
16.
Using a
5
⁄
16
” nut driver or standard screwdriver, remove the 2 X energy chain mounting
bracket mounting screws and set bracket to the side. See Figure 4-210.
Figure 4-210: X motor energy chain mounting bracket mounting screw locations
17.
Using a
5
⁄
16
” box wrench, remove the outer Y belt retaining clip mounting screws from
the left side. See Figure 4-211.
18.
Using a
5
⁄
16
” box wrench, loosen, but do not remove, the inner Y belt retaining clip
mounting screws from the left side. See Figure 4-211.
19.
Pull the left side Y belt out from the retaining clip.
Figure 4-211: Left side Y belt retaining clip mounting screw locations
20.
Using a
5
⁄
16
” box wrench, remove the outer Y belt retaining clip mounting screws from
the right side. See Figure 4-212.
21.
Using a
5
⁄
16
” box wrench, loosen, but do not remove, the inner Y belt retaining clip
mounting screws from the right side. See Figure 4-212.
22.
Pull the right side Y belt out from the retaining clip.
Remove the 2
mounting screws
Remove the outer
mounting screws
Loosen, but do not
remove the inner
mounting screws