Stratasys uPrint, Service Manual, Page: 130 / 383

uPrint/uPrint SE Service Manual 4-83
Figure 4-140: Disconnecting the umbilical cable
5.
Disconnect the model and support thermocouple wires by pulling outward. See Figure 4-
141.
Figure 4-141: Thermocouple wire locations
6.
Using a
1
⁄
4
” nut driver or standard screwdriver, remove the 3 mounting screws and
remove the TC Amp board. See Figure 4-142.
Figure 4-142: TC Amp board mounting screw locations
Installing the TC Amp board
1.
Align the TC Amp board with the mounting holes.
2.
Using a
1
⁄
4
” nut driver or standard screwdriver, reinstall the 3 mounting screws.
3.
Reconnect the model and support thermocouple wires.
4.
Reconnect the umbilical cable.
5.
Reinstall the right side access panel.
6.
Reinstall the side panels. See Installing the side panels on page 4-8.
7.
Reinstall the top panel. See Installing the top panel on page 4-6.
Disconnect the
umbilical cable
Disconnect the support
thermocouple
Disconnect the model
thermocouple
Remove the 3
mounting screws