Stratasys uPrint, Service Manual, Page: 113 / 383

4-66
Installing the substrate sensor
1.
Align the substrate sensor with the mounting holes.
2.
Using a
3
⁄
32
” allen wrench, reinstall the 4 substrate sensor mounting screws.
3.
Reconnect the substrate sensor wire to the head board.
4.
Reinstall the wire tie around the head motor and wires. See Figure 4-111.
Figure 4-111: Wire tie location
5.
Align the right side access panel with the mounting holes.
6.
Using a
5
⁄
16
” nut driver, reinstall the right side access panel mounting screws.
7.
Reinstall the side panels. See Installing the side panels on page 4-8.
8.
Reinstall the top panel. See Installing the top panel on page 4-6.
Reinstall the wire
tie around the
head motor