Stratasys uPrint, Service Manual, Page: 103 / 383

4-56
Head Components
Head Cooling Fan
Required Tools
•
5
⁄
16
” nut driver or standard screwdriver.
•
7
⁄
64
” allen wrench.
Hardware
• 6-32 x 1
3
⁄
4
” flat head cap screws (x2)
Removing the head cooling fan
1.
Remove the top panel. See Removing the top panel on page 4-5.
2.
Remove the side panels. See Side Panels on page 4-7.
3.
Remove the upper electronics bay cover. See Removing the upper electronics bay cover
on page 4-17.
4.
Disconnect the J258 cable by pressing the tab and pulling the connector apart. See Figure
4-92.
Figure 4-92: J258 cable location
5.
Using a
7
⁄
64
” allen wrench, remove the 2 mounting screws. See Figure 4-93.
Disconnect J258