Stratasys ProBleacher Product Guide
Setup
Page 6
© Copyright 2021 Stratasys. All rights reserved.
6. Remove, read, and keep the
Important
insert for reference.
7. Remove the product from the inner box.
8. Remove the product from the protective bag. Hold the door to prevent it from opening while
removing the product from the box.
9. Place the product on a stable work surface.
10. Return packaging materials to the outer box and store them for future use, if necessary.
Setup
1. Verify that the power switch is in the off (0) position.
2. Insert the power cord into the power inlet at the back of the unit.
3. Plug the power cord into a power outlet.
Operation
1. Switch on (I) the power switch on the back panel. The power switch has a red light when
on, and the display screen turns on.
2. Open the front door and place the printed part(s) to be processed into the chamber.
Operation Modes
This product has the following operation modes:
• Preset modes - not used for PolyJet materials.
• Custom mode - used for parts printed with PolyJet printers.
To photobleach the parts:
1. Immediately after printing and cleaning, place the part(s) in ProBleacher.
2. Arrange the printed parts in the cabinet with enough distance between them to allow light to
reach all sides of each part.
3. Close the door.
4. Select
Custom
from the menu on the display.
Figure 1: Operation modes
Custom
mode
