Eden260V User Guide
6 Operating and Maintaining the Printer
DOC-32020 Rev. F
6-10
Resuming Production After Printing has Stopped
If the printing process is interrupted, Job Manager stops sending slices to the
printer. This can happen, for example, if the printing material runs out in the
middle of a print job, and you do not replace the empty cartridge immediately.
After the printer changes to
Standby
or
Idle
mode, you need to resume printing
from the
Job Manager
screen of Objet Studio.
After printing stops, the printer goes into
Standby mode
, when heating of the
print heads is reduced. About 10 hours later, the printer goes into
Idle
mode,
when heating of the print heads is stopped.
To continue printing the model:
1. If the printer is in
offline
mode, switch it to
online
mode by clicking the red
button at the bottom of the printer interface (see the figure on page 6-4).
The button changes from red to green.
2. If you don’t know why printing has stopped, make sure that the connection
between the printer and the server computer is active.
3. In the
Job Manager
screen of Objet Studio, click the
Resume
icon
.
4. In the
Continue from Slice
dialog box that appears, confirm the slice number,
after checking the printer interface.
Figure 6-6 Printer interface after interrupted printing
Figure 6-7
Continue from Slice
confirmation in Objet Studio (
Job
Manager
screen)
5. If, for any reason, the correct number does not appear in the dialog box, enter
the number and click
OK
.
