Eden260V User Guide
5 Using Objet Studio
DOC-32020 Rev. F
5-68
Material Consumption
•
Actual
—the amount of material used till now
•
Required
—the amount of material still needed to finish the job
Tray Preview
The
Tray Preview
panel displays the build tray view of the job selected in the
Job
Queue
or the
History
list.
On a server, you can open an enlarged preview window by clicking on the
Tray
Preview
display (see "Additional Server Features" on page 5-76).
Waste
The amount of waste appears when the cursor is over the
Waste
display.
Setting the Printer Connection
When your printer is installed, the server computer is connected to that printer.
Normally, there should be no reason to change this connection. Occasionally,
however, you may need to reset the connection, to connect the server to another
printer, or to use Objet Studio in offline mode (without a printer connection).
To set (or change) the printer connection:
1. On the
Job Manager
ribbon, in the
3D Printer
group, click
.
2. In the
Set Printer
dialog box, click
Connect
.
Figure 5-82
Connecting to a printer (A)
