10
www.strata.co.nz
ADVANCETIG 200
Any Strata ADVANCETIG model can be config-
ured to communicate exclusively with any Strata
wireless foot pedal or remote control panel. This
is done by a simple process of synchronising
the wireless remote control and the machine
frequencies. Each interface frequency assigned
is unique, so it is possible to use several wire-
less control systems/ machines in the same area
with no problems. The direct range of the Strata
wireless control system is approximately 100m,
this will be affected by the physical location of the
machine and the remote control.
To synchronise a remote control to a
machine, follow these instructions:
1.1 Ensure the remote control or foot pedal is
switched on
1.2 Press and hold the main control adjust-
ment knob in ‘select’ mode and turn the
machine on.
1.3 As the machine powers up, the LCD display
will light and then go blank again. When
the display goes blank, release the control
knob.
1.4 Within 10 seconds of releasing the knob,
activate the remote control or foot pedal.
The LCD display on the machine should
blink twice to indicate successful synchro-
nisation. Switch the machine off and back
on again to start welding operation. If the
operation is unsuccessful, repeat steps 1
to 5.
Please ensure the wireless foot pedal or remote
control is switched off when not in use to con-
serve battery life. If the battery is left to go flat,
the remote device may be required to be resyn-
chronised with the machine again.
Wireless Remote Control Configuration:
To remove the connection with a wireless
remote control:
2.1 Press and hold the main control adjust-
ment knob down in ‘select’ mode and turn
the machine on.
2.2 Continue holding the knob down after
the LCD display goes blank. Eventually
the display will blink with a wireless reset
message.
2.3 Switch the machine off and back on again
to start welding operation. The wireless
synchronisation has now been removed.
12 Pin Remote Plug Connection
5
2
1
3
4
6
7
8
9
10
11
12
1
2
3
4
5
6
7
8
9
10
11
12
2
5G
4
6
5G
7
8
3
5G
1
5G
No
Connect
short
circuit
potenti
potentiometer
potentiometer -
-
-
switch
-
-
-
Pin
No.
Spin
Socket
Shell
Wire
Foot
Pedal
-
-
-
-
-
-
-
switch
-
-
-
Common
Welding
Torch
-
-
potenti
potentiometer
potentiometer -
-
-
switch
short circuit
-
-
Remote
Control
Torch
-
-
-
-
-
up
down
switch
-
-
-
Up-
Down
Torch
centre tap
centre tap
