2
Quick Start Guide
ViSion.net 8-Port
diGital inPut Module
443581626883
WARNINGS AND NOTICES
When using electrical equipment, basic safety precautions should always be followed including the following:
• For indoor, dry locations use only. Do not use outdoors.
• Do not mount near gas or electric heaters.
• Equipment should be mounted in locations and at heights where it will not readily be subjected to
tampering by unauthorized personnel.
• The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition
and void warranty.
• Not for residential use. Do not use this equipment for other than intended use.
©2021 Signify Holding. All rights reserved.
All trademarks are owned by Signify Holding or their respective owners. The
information provided herein is subject to change, without notice. Signify does
not give any representation or warranty as to the accuracy or completeness of
the information included herein and shall not be liable for any action in reliance
thereon. The information presented in this document is not intended as any
commercial offer and does not form part of any quotation or contract, unless
otherwise agreed by Signify. Data subject to change.
CUSTOMER SERVICE
If you have any questions regarding this product,
please contact Customer Service by phone at
+1 214-647-7880 or by email at
entertainment.
.
2
reQuireMentS
• The Vision.Net 8-Port Digital Input Module is pr24 V DC
over the Vision.Net interface. Do not attempt to power the module
from a separate power supply.
• The recommended wire for interfacing Vision.Net is Belden 1583a
(Cat5e, 24 AWG, Solid).
• The recommended wire size for connecting sources is 16-28 AWG.
To connect Vision.Net 8-Port Digital Input Module to Digital Input
Sources:
Step 1.
Remove applicable screw-down connector from module.
Step 2.
Prepare wire and insert into connector observing polarity of
the source, if required. Use a slotted screwdriver to tighten
the screw down terminals.
Step 3.
Align and evenly re-insert the connector back into the
module.
SURFACE MOUNT BRACKET CAN
BE MOUNTED HORZONTALLY
OR VERTICALLY AS SHOWN
LED INDICATORS
PWR: Solid green when module is powered
TX: Flashes green when signal transmitted
RX: Flashes red when signal received
VN: Flashes red to indicate the binary Vision.Net ID
IN: Flashes red to indicate which inputs are active
OUT: Flashes red to indicate which outputs are active
LSB - Least Significant Bit
MSB - Most Significant Bit
1-8: Flashes green status of inputs. Display using MODE button.
CONFIGURATION BUTTONS
MODE: toggles LED display between VN, IN, and OUT
PRM: advanced programming for Certified Technicians
INC: advanced programming for Certified Technicians
DEC: advanced programming for Certified Technicians
