1
Quick Start Guide
ViSion.net 8-Port
diGital inPut Module
443581626883
OVERVIEW
This document provides installation and operation instructions for the following product(s):
PRODUCT NAME
ORDER CODE
Vision.Net 8-Port Digital Input Module
53904-108
inStallation and Set uP
din rail MountinG
To mount Vision.Net 8-Port Digital Input Module on compatible
TS35/7.5 DIN rail:
Step 1.
Tilt the module backwards slightly.
Step 2.
Fit the module over the top hat of the DIN rail.
Step 3.
Slide module down until fully engaged with the top hat.
Step 4.
Push the module forward to engage to the DIN rail fully.
Step 5.
Gently rock the module back and forth to assure it’s locked
in place.
To remove unit(s) from DIN rail:
Step 1.
Turn off and disconnect wiring.
Step 2.
Gently pry the module from the bottom using a slotted
screwdriver if required.
SurFace MountinG
To mount Vision.Net 8-Port Digital Input Module on a surface:
Step 1.
Determine appropriate orientation of your module for your application - vertical or horizontal.
Step 2.
Using the surface mount bracket as a template mark the location of the keyholes on the mounting
surface.
Step 3.
Install appropriate fasteners for your application. The keyholes accept two #6 rounded head screws.
Step 4.
Remove DIN rail bracket from module by removing two Phillips head screws with a #2 driver. Save
bracket for future use.
Step 5.
Attach surface mount bracket to module using two Phillips head screws observing the desired orien-
tation.
Step 6.
Hang the module on the fasteners installed in Step 3 and hand-tighten.
3
1
2
4
Click
