Vision.net RS232 Interface Port
Installation & Operation Guide
1
Important Safeguards
TABLE OF CONTENTS
Overview ................................................................................................................................... 2
Vision.net System Overview............................................................................................. 2
Vision.net RS232 Serial Interface Port Overview ............................................................ 2
Installation ................................................................................................................................. 3
Installation Steps ............................................................................................................... 3
Operation ................................................................................................................................... 4
Communication Modes ..................................................................................................... 4
ASCII Codes For Vision.net Show Control Protocol ....................................................... 4
Specifications ............................................................................................................................ 5
When using electrical equipment, basic safety precautions should always be followed
including the following:
a.
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
.
b. Do not use outdoors.
c. Do not mount near gas or electric heaters.
d. Equipment should be mounted in locations and at heights where it will not
readily be subjected to tampering by unauthorized personnel.
e. The use of accessory equipment not recommended by the manufacturer
may cause an unsafe condition.
f. Do not use this equipment for other than intended use.
g. Refer service to qualified personnel.
SAVE THESE INSTRUCTIONS
.
WARNING:
You must have access to a main circuit breaker or other power
disconnect device before installing any wiring. Be sure that power is disconnected
by removing fuses or turning the main circuit breaker off before installation.
Installing the device with power on may expose you to dangerous voltage and
damage the device. A qualified electrician must perform this installation.
WARNING:
Refer to National Electrical Code® and local codes for cable
specifications. Failure to use proper cable can result in damage to equipment or
danger to persons.
CAUTION:
Wire openings MUST have fittings or lining to protect wires/cables
from damage. Use 90° C copper wire only!