Strand 200 Console Manual
Page 21
Advanced Features
The advanced features section will cover advanced programming items such as effects,
scene editing and setup.
Effects
The effects feature of the 200 console, allows the operator to program and run a sequence
of levels or cues at a rate that ranges from 0.05 seconds to 10 seconds per step or stepped
through manually or triggered by an audio / MIDI signal.
There are 4 pages of 6 effects per page with a maximum of 99 steps per effect.
Programming an Effect
The grouping of keys at the bottom right of the 200 console
is the effects tile.
Select the effect page by toggling the FX page button.
(The LCD screen will display the current effect page)
Press the record key, the “record”
ndicating the
console is now in record mode and
Press the corresponding
effect’s number key to record that effect. The yellow LED above
that button will start flashing indicating that it is ready to record.
Set the desired fader(s) (while in either one scene or two scene mode) or
scene(s) (while in submaster mode) to the preferred level and then press step
to record that step. The LCD screen will display all relevant information.
Notice that the effect step will advance from 1.01 to 1.02 (with the first digit being the effect
number). Change the fader levels to the desired levels in step 2 and press step to record
that step. Repeat for as many as 99 steps. After recording the steps, select the effect mode
and direction and step time (see below for mode and direction information), then press the
LED will light up i
ready.
