PAGE 24 — STOW MS-70 MIXER — OPERATION MANUAL — REV. #3 (03/26/10)
4.
Turn the engine switch (Figure 14) to the
ON
position.
5.
The main
start/stop
switch located on the engine cover is
(Figure 15) is used to start and stop the engine. Pull this
switch outward to start the engine.
6.
Place the
belt slip lever
(Figure 16) in the
START/STOP
(disengaged) position.
Figure 16. Belt Slip Lever
(Start/Stop Position)
7.
Pull the
starter grip
(Figure 19) lightly until you feel
resistance, then pull briskly. Return the starter grip gently.
Figure 19. Starter Grip
Figure 18. Drum Lock Pin (Right Position)
Figure 17. Drum Lock Pin (Side-View)
Make certain the
drum lock pin
(Figures 17
and 18) is placed
to the
RIGHT
(when viewing the mixer from the towpole end)
of the drum stop block which is welded to the front side of the
drum. Also make sure lock pin is fully engaged (locked). This
will prevent the drum from tipping.
CAUTION
CAUTION
CAUTION
CAUTION
CAUTION
Figure 15. Start/Stop Switch (gasoline engine)
Figure 14. Engine ON/OFF Switch
Preventing Drum Tipping
MS-70 PLASTER/MORTAR MIXER — START-UP PROCEDURES
