Step 2: Connect to the electricity
supply
We recommend that the appliance is
connected by a qualified electrician,
who is a member of the N.I.C.E.I.C.
and who will comply with the I.E.E.
and local regulations.
Important:
Ensure that you route all
mains electrical cables well clear of
any adjacent heat source, such as an
oven or grill.
Warning:
This appliance must be
earthed.
1. Where a fixed connection is used,
a device allowing the appliance
to be isolated on all poles from
the mains supply with a contact
opening width of at least 3 mm
must be provided.
Use a 13 amp fuse.
2. A type HO5 V V-F cable must be
used as the mains lead. The cross
section must be 2.5 mm
2
.
3. The mains terminal block is
positioned at the right hand rear of
the top service panel.
5. Connect the cable to the terminal
block, and tighten the cable clamp.
6. Close the terminal box, ensuring
that the cover is engaged on the
locking tabs.
Step 3: Check edging strip
The edging strip is factory fitted to
the front side edges of the appliance
front frame. This strip provides the
cabinetry with extra protection from
any escape of heat.
When installing the product, ensure
that the edging strip is correctly located
on the outer edges of the front frame,
before positioning and securing the
appliance to the cabinet.
When securing the appliance, the
fixing screws provided are driven
through the edging strips into the
cabinet - the seal will straighten up
and sit flush to the cabinet when the
screws are fully home.
Step 4: Secure appliance into
housing unit
Note:
The unit housing the appliance
must be appropriately fixed.
Open the oven door and screw 2
screws through the top corner holes in
the front frame.
26
Installation Instructions
seal
front frame
door
handle
23468 05 - EL 616 11/07/2002 10:11 Page 28
