When you are cooking keep
children away from the vicinity
of the oven.
Manual operation
The oven cannot be used manually
when the programmer is set for
automatic cooking. If auto is showing
on the programmer display, press the
cook time and ready time buttons
simultaneously to cancel the automatic
setting and return to manual operation.
Turn the control knob anticlockwise to
the required gas mark setting.
There is a short delay before ignition
whilst the cooling fan starts and runs
up to speed.
The ignition unit will
spark for approximately four seconds
to light the burner; if ignition does not
occur, the computer will close the gas
valve for 12 seconds to allow any
unburnt gas to disperse, before
attempting ignition again.
This
sequence will occur automatically a
further 4 times only. The green lamp
will flash if ignition does not occur
within 4 attempts. The computer may
be reset if ignition has not occurred,
by turning the control off then on
again to the required setting.
The oven cannot be used manually
when the programmer is set for
automatic cooking; if
A
(AUTO) is
showing on the programmer display,
press the
cook time and
ready
time buttons simultaneously to cancel
the automatic setting.
Main oven ignition
Turn the control knob anticlockwise to
the required gas mark.
To turn off, return the control knob to
the “off” position.
Automatic operation
See ‘Programmer / Clock’ section.
We recommend that 15 minutes is
added to the cooking time when using
the automatic cooking facility, to allow
for preheating.
Oven light
All oven lamps will light when an oven
is in use.
Note:
As part of the cooking process, hot air
is expelled through a vent at the top of
the oven(s). When opening the oven
door, care should be taken to avoid
any possible contact with potentially hot
air, since this may cause discomfort to
people with sensitive skin. We recommend
that you hold the underneath of the
oven door handle.
Warning:
Do not use the oven(s) if
the fan is not working.
10
USING THE MAIN OVEN
