STOVES 444444331, User Manual

Page: 7 / 25

EN -6-
Installing and operating your fridge
Before starting to use your fridge, you should pay attention to the following points:
• Operating voltage for your fridge is 220-240 V at 50Hz.
• The plug must be accessible after installation.
• There can be an odour when you first switch on the appliance. It will disappear after the
appliance starts to cool.
• Before making the connection to the power supply, ensure that the voltage on the
nameplate corresponds to the voltage of electrical system in your home.
• Insert the plug into a socket with an efficient ground connection. If the socket has
no ground contact or the plug does not match, we suggest you to call an authorized
electrician for assistance.
• The appliance must be connected with a properly installed fused socket. Power supply
(AC) and voltage at the operating point must with the details on the name plate of the
appliance (name plate is located on the inside left of the appliance).
• We do not take responsibility for damages that occur due to ungrounded usage.
• Place your fridge in a place that it would not be exposed to direct sunlight.
•
Your fridge should never be used outdoors or left under the rain.
• Your appliance should be at least 50 cm away from stoves, Gas ovens and heater cores,
and should be at least 5 cm away from electrical ovens.
• When your fridge is placed next to a deep freezer, there should be at least 2 cm between
them to prevent humidity on the outer surface.
• Do not place heavy items on the appliance.
• Clean the appliance thoroughly, especially in the interior, before use
(See Cleaning and Maintenance).
• Installation procedure is given in the Installation Manual. This product is
intended to be used in proper kitchen units only.
• The adjustable front legs should be adjusted to an appropriate height to
allow your freezer to operate in a stable and proper way. You can adjust
the legs by turning them clockwise (or in the opposite direction). This should be done
before placing food in the freezer.
• Before using your fridge, wipe all parts with warm water added with a
tea spoonful of sodium bicarbonate, and then rinse with clean water
and dry. Place all parts after cleaning.
• Install the distance adjustment plastic (the part with black vanes at the
rear) by turning it 90° as shown in the figure to prevent the condenser
from touching the wall.