Installation Instructions Continued
Updated: 8-27-2019
5. Assemble Attachment Arms:
Slide the Attachment Arms (B) over
the installed Mounting Rod (A) aligning the holes on the bottom
of the rod as shown in image 1. The U-Shape hooks shall face
upwards and away from the wall. Utilizing the provided hex tool,
secure the attachment arms to the mounting rod by installing set
screw (C) so that it achieves a very snug and rigid connection.
6. Test Fit Bike:
Place the bike to be stored on the rack on the u-
shaped hooks as shown in image 3 below.
Note: Bike frame
configurations vary widely and may differ from that shown below.
THE
Naked Rack
for
BIKE
PART OF THE
Naked Rack
LINE OF PRODUCTS
We value your feedback:
Help others by leaving a review of your
experience with this rack. We at SYB
greatly value feedback, and continually
look for ways to improve our products to
meet your storage needs!
8. Load Bike:
Load bike on the installed rack.
9. (Optional) Install Strap:
A hook and loop strap is provided for
your use to keep the front wheel from rotating and pivoting into
the wall while the bike is stored on the rack. If desired, wrap the
hook and loop strap (shown in image 2) thru the spokes on the
front wheel and then around the bike frame so that the front
wheel is strapped to the frame to keep wheel from rotating and
pivoting.
Enjoy your new Bike Rack!
7. Adjust Support Angle:
Remove
the bike from the rack. Loosen
both lag screws installed to the
wall slightly a few turns and
adjust the angle of the rack to
the desired position as to
support the bike level with the
ground. After adjusting angle,
fully secure lag screws to the
wall. Repeat as necessary to
achieve the desired support
angle.
Image 1 – Set Screw Location
Image 2 – Hook and Loop Strap
Image 3 – Installed Bike Rack
