10
Installation
StorCase Technology, Inc.
DX115 for Backup User's Guide - Rev. A01
Figure 7: Receiving Frame Mounting Holes
Installing the Receiving Frame
NOTE:
Use a #2 Phillips screwdriver for this procedure.
The drive should be installed into the carrier before installing the receiving frame into the
mounting bay of a computer or expansion chassis.
1.
Turn OFF power to the computer.
2.
Open the computer system according to the manufacturer’s instructions. If neces-
sary, temporarily remove any expansion boards that may make installation difficult.
3.
With the drive carrier locked in place inside the receiving frame, install the DX115
into the 5.25” drive opening in the computer or expansion chassis. Use the appro-
priate guides to position the Data Express, and fasten it into place with the four
(4) M3 Phillips screws provided. Figure 7 illustrates the location of the mounting
holes. Mounting holes are provided on each side and the bottom of the receiving
frame to accommodate a variety of mounting configurations. Use the mounting holes
which best suit the computer or expansion chassis configuration. Note that bottom
mounting holes require self-tapping screws (not provided).
4.
Adjust the front of the receiving frame so the carrier slides freely in and out on the
receiving frame guides. The position of adjoining peripheral units may require ad-
justment.
Mounting
Holes
(Left)
Mounting
Holes
(Right)
Mounting
Holes
(Bottom)
