StorageTek L180, Service Manual

Page: 133 / 266

95897 Fifth Edition 4-43
MPC Card
CAUTION:
Possible equipment damage: Grasp the cable housing, not the cable itself.
10. Remove the SCSI jumper cable from the lower right section of the MPC card.
1. SCSI jumper cable
CAUTION:
Possible equipment damage: Make sure the screws do not fall into the fan assembly.
11. Use a T-10 Torx bit to remove the 14 screws from the card.
12. Use a 1/4-in. nut driver to remove the three standoffs from the card.
1. Screw (14)
2. Standoff (3)
CAUTION:
Possible equipment damage: Be careful not to damage the cables when you remove
the card.
13. Tilt the right side of the card into the slot until the left side is free.
14. Tilt the left side of the card toward you and remove it.
E67150
1
E67155
2 1