17
SAFETY
CIRCUITS
2.7.6
Please note that on older STEPCRAT control boards when the UC100 module powers down
during use the spindle can start up if left on and in CNC mode. This has been rectified in
more recent versions of the STEPCRAFT mainboard.
Therefore when in CNC mode it is imperative that you act with extreme caution when using
your industrial CNC spindle.
3 S
ETUP
S
YSTEM SETUP
3.1.1
Plug the interface cable into the back of the STEPCRAFT and into the back of the Industrial
spindle control box. See Figure 2 for how this is carried out.
Figure 2: Interface cable connection
Summary of Contents for STEPCRAFT
Page 20: ...20...