6
SM0974202 A 04
System manual
2.1. Set MirrorEye 1 Layout
See
Figure 4
1. Camera MirrorEye 1 Left Side; Article No. 0106001
2. MirrorEye 1 12.3” Monitor unit, Driver; Article No. 0212000
3. Camera MirrorEye 1 Right Side; Article No. 0106011
4. MirrorEye 1 12.3” Monitor unit, Passenger; Article No. 0212500
5. Vehicle Display Controller; Article No. 1001743
2.2. Power folding
Folding is used to protect the camera-module against low speed
impact and reduce the width of the vehicle. For driver convenience
folding is automated by a power folding element. See figure 3.
2.3. Camera and monitor mounting positions
The camera position must as far to the front of the Vehicle as
possible, see figure 4, to ensure that the class IV image can be
captured, see also figure 1, page 3. For drilling template camera
bracket see page 9.
The monitor position can be determined according to the table
below and the dimensions according to figure 4.
Class
Location
Design viewing
Design viewing
Distance ORP
angle horizontal
angle vertical
to monitor
Class II
driver
-5
-5°
80 cm
Class IV
driver
-5
5°
80 cm
Class II
passenger
0
-2°
191 cm
Class IV
passenger
0
2°
191 cm
Figure 4
1
2
3
4
5
1
2
3
4
1
2
Seat rails
Seat rails
745
745
3100
Ocular Reference Point
45
30
200
Ocular
Reference
Point
200
A Pillar
A Pillar
A Pillar
Dimensions in mm
The specified dimensions and angles are based on the
Stoneridge-Orlaco test vehicle, these installation dimensi-
ons apply only for vehicles with similar dimensions, actual
dimensions and angles are specified for each type of vehicle
by Stoneridge-Orlaco.
Set Article number: 0416100
