1
Revision102715
Motion Activated 1200 Lumen
LED Security Light
Model: 1G1200M-PB/1G1200M-PW
Please read all instructions thoroughly and carefully prior to installing this product.
Retain these instructions for future reference.
Failure to follow these instructions could result in voiding the product warranty.
Keystone Group assumes no liability or responsibility for claims arising from improper installation or improper use.
For questions in regard to warranty of this product contact us at 855.652.6164, Monday through Friday, 7:00am to 4:00pm MST
or email us at [email protected].
READ FIRST:
IMPORTANT SAFETY INSTRUCTIONS
Before you begin installing, servicing, or maintenance of this product, follow these general precautions.
•
To reduce the risk of death, personal injury or property damage from fire, electric shock, falling parts, cuts/abrasions and
other hazards please read all warnings and instructions included with and on this product prior to installation.
•
For commercial installation: service and maintenance of this product should be performed by a qualified, licensed
electrician.
•
For residential installation: If you are unsure about the installation or maintenance of this product, consult a qualified
licensed electrician.
•
Do not mount the unit against flammable surfaces.
•
This product is intended to be used outdoors, and be subject to the elements; such as rain and snow and we recommend it
to be mounted at least
6’ 6”
off the ground
•
This LED product must be powered directly to a switched circuit.
•
This product should not be used in areas with limited ventilation or high ambient temperatures.
•
This product CANNOT be used with a dimmer switch, motion or occupancy sensor or other electronic switching device.
•
This product is intended to be connected to a properly installed and grounded UL listed junction box.
WARNING: RISK OF ELECTRICAL SHOCK
•
Turn off electrical power at fuse or circuit breaker box before wiring product to the power supply.
•
Verify voltage is 110-240V before installing.
•
Make all electrical and grounded connections in accordance with the National Electric Code and any applicable local code
requirements.
•
All wiring connections should be capped with UL listed wire connectors.
CAUTION: RISK OF PRODUCT DAMAGE
•
Never connect fixture with power on.
•
Do not mount or support product in a manner that can cut the outer wire jacket or damage the wire insulation.
•
Avoid covering LED products with insulation, foam, or other materials that will prevent convection or conduction cooling.
•
Never connect an LED product directly to dimmer packs, occupancy sensors, timing devices, or other related control devices,
unless individual product specifications deem otherwise.
