Stonegate Novelle AFS-540LC Installation And User Instructions Manual Download Page 3

 

23.

 

Do not burn wood or other materials in this fireplace. 

24.

 

Do not strike fireplace glass. 

25.

 

If the heater unit has been dropped or damaged, do not operate unless fully checked out by a 

certified repair center. 

26.

 

Always use a certified electrician should new circuits or outlets be required. 

27.

 

Always use properly grounded, fused and polarized outlets. 

28.

 

Always use ground fault protection where required by electrical code. 

29.

 

WARNING

  –  Always disconnect  the unit from the power supply before performing any 

cleaning, light bulb replacement, maintenance or relocation of the electric fireplace. 

30.

 

When transporting or storing the fireplace and cord, keep in a dry place, free from excessive 

vibration and store so as to avoid damage. 

31.

 

The electric fireplace may emit a slight, harmless odor when first used. This odor is normal and 

it is caused by the initial heating fireplace.   

32.

 

CAUTION:

  The front panel is not permanently fixed to the base unit. DO NOT lift the 

appliance by the front panel. 

 

NOTE

: Procedures and techniques that are considered important enough to emphasize. 

 

CAUTION

: Procedures and techniques, which, if not carefully followed, will result in damage to 

the equipment or personal property or may cause personal injury. 

 

WARNING

: Procedures and techniques, which, if not carefully followed, will expose the user to 

the risk of serious injury, illness or death. 

WARNING

This heater and parts become hot when in use. The area directly around, under, and above the heater 

element must be clear and free of any obstructions.   

 

DO NOT ALLOW CHILDREN TO OPERATE. KEEP CHILDREN AND PETS AWAY 

FROM THE HEATER AND CONTROLS.  THE HEAT COMES OUT THE VENT ON THE 

TOP OF THE UNIT.    DO NOT PLACE OBJECTS ON TOP OF THE HEATER UNIT.    DO 

NOT TOUCH OR LEAN ON THE TOP OF THE HEATER UNIT, THIS IS A HOT 

SURFACE. 

Choosing a Location for the Fireplace Heater: 

When choosing a location in your home, ensure that the general safety instructions are followed.    For 

best results, install out of direct sunlight.  The heat vent is on the top of the unit so keep that in mind 

when deciding where to locate your fireplace.  FOR SAFETY PURPOSES, IF UNIT IS FREE 

STANDING ON THE FLOOR, USE COMMON SENSE AND KEEP THE UNIT IN A LOCATION 

OUT OF DIRECT TRAFFIC AND AWAY FROM WHERE CHILDREN OR OTHERS WON’T 

BUMP INTO IT. 

 

For Wall Mounted Installation: 

Make sure that the wall is capable of supporting the combined weight of the appliance. If necessary 

have a qualified technician reinforce the wall.   

Summary of Contents for Novelle AFS-540LC








Reviews: